Office Hours: Sat - Thu. 9:00 AM To - 7:30 PM
Call Us For Support +91 83202 72550
Send Email info@krushnamtubes.com

Raw Material

Home / Products

Raw Material - Aluminium

Aluminium is a soft, lightweight, non-toxic and malleable metal with appearance ranging from silvery to dull gray depending on surface roughness. Aluminium alloys have yield strengths ranging from 200mpa to 600mpa. For Prime Pex MLC Pipes, a specialised grade of Aluminium is used which is manufactured specifically for these pipes and have the right balance of strength and flexibility as required for bending applications.

Thermal Conductivity

0.45W/M.K. - ABOUT 1/100 of steel pipe but not only serveral times higher than that of insulating materials. No need of insulation Prime Pex Hot Water Pipes. Prime Pex Pipes have an extremely low co-efficient of linear expansion 25 X 10-6 m/m.k., only 1/8th of all polyethylene pipes, almost same as that of aluminium pipes.

SPECIFICATION (MM)
BURST PRESSURE (MPa)
PIPE RING STRENGTH (N)
1014
7.00
2100
1216
6.00
2300
1620
5.00
2500
2025
4.00
2500
2532
4.00
2500
3240
4.00
2800

Raw Material - Polyethylene

Polyethylene or PE is a polymer consisting of long chains of the monomer ethylene. It is created through the polymerization of ethene and is classified into different types based on Density. High density polyethylene or HDPE is used to manufacture Prime Pex MLC Pipes. It has a low degree of branching and thus stronger inter-molecular forces and tensile strength. The Polythelene used in Air Connect Pipes is food grade and hence hygenic.